![]() Fortigate – how a special character (+) could break VPN with Firmware 6.0.Elementor Pro vs Elementor Free: Complete Comparison 2023. ![]() This is my situation, so do you recommend to join my Synology Directory Server to my existing Windows domain so the Synology acts as a secondary domain controller instead? I need to transfer some folders and files shares off the old Windows 2008 Server and I think making the Synology act as a secondary domain controller will help me. So far so good, so my question for you is the following: In your Q&A Section you state “However, if you already have a licensed Windows Server, I would not switch your Domain to a Synology NAS”. The Host CPU percentage in Synology Virtual Machine Manager reaches a maximum of 16% but at idle stays at only 3%. I have been testing all day and the 20 computers on the local network connected to this new Windows Server 2016 VM. Configured with virtual 8 GB memory, 4 CPU(s), 2 Reserved CPU Threads and 40 GB virtual disk. The Windows Server 2016 Virtual Machine inside Synology Virtual Machine Manager is running on a two drive SSD volume. I just completed a Domain Controller / Active Directory / DHCP / DNS migration from an old Dell PowerEdge server running Windows Server 2008 R2 to a new Windows Server 2016 running as a Virtual Machine in Synology Virtual Machine Manager on my DS1821+ with 64 GB of total physical memory. Important: Do not install a new drive when the system is not in degraded mode, otherwise you may encounter unexpected system failures.Greetings Great review, I learned a lot from your guide. You can check the disk volume information in the System Logs.RAID 5 mirroring protection is now active. When the rebuilding is completed, the Status LED will be in green and the volume status will change to Ready.If you check the RAID Group in the Storage Pool section, the status will be Rebuilding and the progress will be shown.The Status LED will alternate between flashing red and green. The new drive should have at least the same capacity as the failed drive. Prepare a new hard drive to rebuild the RAID configuration.Please follow the below steps to hot swap the failed hard drive: Install a new drive to rebuild RAID 5 by hot swapping For these settings, please refer to the System Settings/ Alert Notification section in the user manual. You can configure your Turbo NAS to send you alert emails by configuring the alert notifications. You can check the System Logs for error and warning messages regarding drive failures and disk volumes being in degraded mode. The volume status will be in Degraded mode. Check the RAID Group in the Storage Pool section.The Status LED will continuously flash red. ![]() The Turbo NAS will beep for 1.5 sec twice when the drive fails.When a drive fails, follow the steps below to check the drive status: When the RAID volume operates normally, the status is shown as Ready under “Storage/Snapshots” > “Manage” > “RAID Group of Storage Pools”. Logical volume status when the RAID operates normally ![]() It is particularly suitable for home or business use in saving important data. The usable capacity in RAID 5 is the size of the smallest member drive. RAID 5 creates an exact copy of data on the member drives and protects data against a single drive failing. You can use three hard drives of the same capacity to create a RAID 5 array. RAID 5 disk mirroring provides highly-secure data protection. Procedure of hot-swapping the hard drives when a RAID crashes
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |